further Information about the concept of MDM Cables

The MDM Cables:

Prices in SFR for Switzerland

Cinch Interconnect stereo cables MDM 2027.
With this cable we use a PE Foam dielectric, and OFC cables, To achieve an affordable cable, which would provide optimum electrical characteristics. We therefore maximise the dielectric value. Careful workmanship assures minimum losses and the reflection factor can almost be eliminated. The excellent values of inductance and capacitance are achieved by ensuring correct geometry within the cable. To eliminate the disturbance from external interference (Magnetic and electrical), we opted for a special graphite shielding in addition to the protection provided by the PVC.
Cinch Interconnect stereo cables MDM 078
These use similar cables as with the MDM 2027, however since the plugs are part of the signal transfer, these are made of a solid non magnetic material, covered by an ABS sleeve. The C 078 plugs are made of a non magnetic material, gold plated and the insulation is made out of Teflon to ensure maximum heat resistance and also best dielectric values. as used for the MDM 078 Cables.
Cinch plug MDM C 078
Cinch Interconnect MDM 1402
With this cable we use the same geometry for the signal conductor as with the ACE. The PCOCC conductors are used for the + signal The PE Foam section is slightly larger than used in the 2027 cables and formed of + PE Foam plus XLPE we then use graphite as shielding between the + and - conductor, so that these cannot have any influence at all on each other. The - conductor is then again surrounded by PVC protection and the polyester mash to eliminate any disturbance from the ambience. The plugs are of the gold plated non-magnetic lock type, with an aluminium cover
Cinch Interconnect MDM 1403 symmetric
With this cable we use the same geometry for the signal conductor as with the ACE. The PCOCC conductors are used for the + signaland - signal. The PE Foam section is slightly larger than used in the 1402 cables and formed of + PE Foam plus XLPE cotton filler is used to have a perfect geometry between the cables. The ground is then also used as a shielding and cosnists of cable strands and a foil.
Cinch plug MDM C1403
The speaker cables ACE
The development of this cable was carried out by using the above mentioned knowledge and of course, like all the MDM cables supported by extensive listening tests. (we worked for three years on this cable) We use two different conductor materials PCOCC and OFC cables in three different sizes. The flow of current is guaranteed with a size of 3.2 mm. To achieve the best and most even geometry of the plus and minus conductors we use a cotton filler. Only in this manner can we achieve the optimum dielectric, capacitance and inductance characteristics To eliminate the ambient factors like magnetic and electrical waves, we use a special graphite shield just inside the sleeve

Precide SA
via V. Vela 33

CH 6834 Morbio Inf.

Tel. 091 6831734 - 35

FAX 091 6836679

E-mail info@precide.ch